Since it takes longer to identify the format of an HDMI signal than it does for other digital audio signals, audio output may not start immediately.You’ve bought yourself the perfect 5.1 surround sound system to enjoy streaming your favorite Netflix series or play your favorite games. Playing DTS program material, using the pause, fast forward, or fast reverse function on your player may produce a short audible noise. This is usually because the DTS bitstream has been processed (e.g., output level, sampling rate, or frequency response changed) and the AV receiver doesn’t recognize it as a genuine DTS signal. With some CD and LD players, you won’t be able to playback DTS material properly even though your player is connected to a digital input on the AV receiver. In such case, you should stop your player for about three seconds and then resume playback. If you switch your player from DTS to PCM, you may not hear any sound because the AV receiver does not switch formats immediately. This is to prevent noise when you use the pause, fast forward, or fast reverse function on your player. When DTS program material ends and the DTS bitstream stops, the AV receiver remains in DTS listening mode and the dts indicator remains on. Make sure the source material is Dolby Digital, Dolby Digital Plus, and Dolby TrueHD. Using cable ties to bundle audio cables with power cords, speaker cables, and the like may degrade the audio performance, so refrain from doing it.Īn audio cable may be picking up interference. Note that the individual speaker volume levels are set automatically after the Audyssey 2EQĬorrection and Speaker Setup has been performed. If the volume level of each individual speaker has been adjusted to high positive values, then the maximum master volume possible may be reduced. (European and Australian models) The Pure Audio listening mode cannot be selected while Zone 2 is on.ĭepending on the number of connected speakers, it is not always possible to select all of the listening modes.Īfter the volume level of each individual speaker has been adjusted, the maximum volume may be reduced. With some DVD-Video discs, you need to select an audio output format from a menu.ĭepending on the input signal, some listening modes cannot be selected. On some game consoles, such as those that support DVD, the default setting is off. When you play source material that contains no information in the LFE channel, the subwoofer produces no sound.Ĭheck the digital audio output setting on the connected device. When the Stereo or Mono listening mode is selected, the center speaker produces no sound. When the T-D (Theater-Dimensional), Stereo or Mono listening mode is selected, the surround speakers produce no sound.ĭepending on the source and current listening mode, not much sound may be produced by the surround speakers. Make sure the speakers are configured correctly. If you use the Dolby Pro Logic II Movie, Dolby Pro Logic II Music, or Dolby Pro Logic II Game listening mode with a mono source, such as an AM radio station or mono TV program, the sound is concentrated in the center speaker. When the Stereo or Mono listening mode is selected, only the front speakers and subwoofer produce sound. The beginning of audio received by an HDMI IN can’t be heard The speaker volume cannot be set as required There’s no sound with a certain signal formatĬan’t select the Pure Audio listening mode
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |